Gigabit Ethernet

Gigabit Ethernet Adapter

The ALLOY-8169V3 is a high performance 32-bit 10/100/1000 Gigabit Ethernet adapter for networks demanding high bandwidth and flexibility. It features Nway Auto-Negotiation for speed selection of 10Mbps, 100Mbps or 1000Mbps, in half-or full-duplex modes. The ALLOY-8169V3 fully complies with all IEEE 802.3ab, 10/100/1000Base-TX standards. Designed with a Realtek single-chip Gigabit Ethernet LAN controller, the ALLOY-8169V3 is fully compliant with Microsoft® NDIS5 (IP, TCP, UDP) Checksum and Segmentation Task-offload features, and supports IEEE 802.1Q Virtual Local Area Network (VLAN). The above features contribute to lowering CPU utilization while providing performance enhancements when operating in high speed gigabit environments.

PCI-E Gigabit 1000Base-SX fibre Network Adapter

Alloy Gem 64 Gigabit NIC Series

The ALLOY GEM64 Gigabit NIC Series is a high performance, cost effective, Fibre Gigabit Ethernet Network Interface card. It is compliant with all the relevant 1000Base-SX and 1000Base-LX standards, and supports SC and LC fibre interfaces. It is PCI 2.2 standards compliant, operates in 32-bit and 64-bit PCI host systems, and supports 33/66Mhz PCI buses at both 5 and 3.3Volts. This enables operation of the card in any PCI format including PCI-X. The Broadcom based controller offers many advanced network features. Host CPU offload support (including TCP/UDP checksum offload), intelligent Interrupt Optimisation, and 9K Jumbo Frame Ethernet packets for maximised network efficiency. Network protocol, configuration, processor specifications, memory, general features and options, and environmental parameters are all important specifications to consider when searching for network cards and network controllers.